The “458 Winchester Magnum, all the cartridge you’ll ever need” thread

[Doug Hamilton]

The .458 WinMag in a Winchester M70 was speed champ for four shots at the first annual Western Ky DR&BB Shoot, 2024.

There is plenty of taper for good feeding in the .458 WinMag.
Ha-ha-ha, the .458 Lott tapers same amount in a greater length cartridge case so it has less taper per inch of length, ha-ha-ha.

FN solids: My Browning Safari balks with second cartridge in the stack of three in the magazine if COL
is over 3.3", but at COL of 3.275" or shorter, no problem. Slick.
That is fortunate for the 500-gr TBSS at 3.275" COL is the standard recommended by Federal, for that bullet in the .458 WinMag which easily does 2200 fps MV from a 24" barrel,
using load data from Federal, for SAAMI ammo.

The CEB Safari Solids have FN meplats with radiused edge and cone angle of nose optimized for feeding and penetration.

 

[Slyfox72114]

Slyfox72114,
Be sure and get it marked with chamber designation.
Of course you should get dies, brass and bullets to make proper ammunition.
The 450 Ackley Magnum dies have been offered as catalog items in the "custom" class in the past, IIRC, they might cost more than the more common stuff, but might be waiting on the shelf somewhere for you, hopefully not something you have to wait for to be custom made.
I got my more obscure 450 Barnes Supreme dies from RCBS.
Try them if they are still in business, or Redding or CH4D.
Brass may be made from blank basic cylindrical.
Peterson sells it as "Wildcat Tubes" and it is of highest quality.
Just run it into the FL sizing die (well lubed) and out pops a 450 Ackley Magnum.
Quality Cartridge (Peter Cardona proprietor) used to have properly headstamped 450 AM brass.

Why did your bolt face look too big in your photo ?
Is the bolt face correct ?
Is the bolt correct ?
Is the headspace correct ?

There is no such thing as a good LOTT,
and you sure as heck do not want to fire one in your rifle until it is checked for proper headspace.

Rifle crank
I’ll do some more checking.
I missed your other post ,but yes I realized I wasn’t measuring to the end of the cartridge.
I have all the players on watch for ammo/reloading dies.I should be getting emails when everything comes in stock. I did order the quality cartridge brass which is out of stock also but it’ll be head stamped right so I’d like to find a laser engraver to make the barrel match and look right.
The old gun deserves a good proper etching.
I also bought a Hornady reloader from an auction last week.So I’m a step closer.

The boltspace is still questionable.
The headspace seems right just adding the correct measurements.
Checking for a local gunsmith here in central Arkansas area. Thanks again!