front bead sight enhancement for ZKK602?

[eshift]

I am working to set up my ZKK 602 for an African hunt with Cape Buffalo on the menu. My primary sight is a 1x5 scope with QD rings but I'd like the original iron sights to be useful for backup if needed. I have cleaned the front sight and it has a silver end attached to it but is not very legible. I was thinking of adding a dab of fluorescent orange paint to it but I would like to get some input from people in the know as I'm guessing here.

 

[Ontario Hunter]

I have done this. You will need to clean the metal first with isopropyl alcohol. Then buy a very fine artist paintbrush at a hobby store. Then prime the spot on the blade with white primer. Shoot a bit of paint into the cap of spray can and use that. See if a white blade does the trick for you. If not, proceed to flourescent orange or green. I also added a small pointer to face of the rear sight V. Make it a different color or the two sights will run together when looking at them. Of course you only need to paint the rear face of the front sight bead. Good luck. If you don't like the look, you can clean off the paint with acetone.

 

[Ontario Hunter]

I once worked rotating shifts at an aluminum plant. Four of them for eight hour shifts: A, B, C, and D. I presume E shift = retired?

 

[IvW]

I am working to set up my ZKK 602 for an African hunt with Cape Buffalo on the menu. My primary sight is a 1x5 scope with QD rings but I'd like the original iron sights to be useful for backup if needed. I have cleaned the front sight and it has a silver end attached to it but is not very legible. I was thinking of adding a dab of fluorescent orange paint to it but I would like to get some input from people in the know as I'm guessing here.

Does it have the pop up rear peep sight or just the express V?

 

[cajunchefray]

I am working to set up my ZKK 602 for an African hunt with Cape Buffalo on the menu. My primary sight is a 1x5 scope with QD rings but I'd like the original iron sights to be useful for backup if needed. I have cleaned the front sight and it has a silver end attached to it but is not very legible. I was thinking of adding a dab of fluorescent orange paint to it but I would like to get some input from people in the know as I'm guessing here.

Try KG Site Cote.
Available from big online gun supply retailers.
I've used both Red and Green, I prefer the Green, but many like the Orange.

It is much more visible than a canned spray paint like Krylon. The fluorescent pigment is easily visible.

Like any paint job, surface preparation is important, as noted below, I used 99% isopropyl alcohol, then acetone. Shake the bottle for a few minutes, it has a small ball bearing that mixes well.
The needle applicator works well on a small bead front. Instructions says dries in an hour, but I cure mine overnight.

After application, immediately clean the needle tip with acetone, or odorless mineral spirits and screw on the cap. It will dry out in a few months, but this gives some shelf life.

Really good paint that is visible in hunting conditions.

 

[Altitude sickness]

Some are using Diamond, zirconia or Swarovski crystals epoxied to the front site

 

[Hunter4752001]

Your other option is to replace the front sight with a fibre optic one from NECG. They have models for the CZ550/ZKK 602

Front Sights | New England Custom Gun Service, Ltd. - Page 2