front bead sight enhancement for ZKK602?

[eshift]

I am working to set up my ZKK 602 for an African hunt with Cape Buffalo on the menu. My primary sight is a 1x5 scope with QD rings but I'd like the original iron sights to be useful for backup if needed. I have cleaned the front sight and it has a silver end attached to it but is not very legible. I was thinking of adding a dab of fluorescent orange paint to it but I would like to get some input from people in the know as I'm guessing here.

 

[Ontario Hunter]

I have done this. You will need to clean the metal first with isopropyl alcohol. Then buy a very fine artist paintbrush at a hobby store. Then prime the spot on the blade with white primer. Shoot a bit of paint into the cap of spray can and use that. See if a white blade does the trick for you. If not, proceed to flourescent orange or green. I also added a small pointer to face of the rear sight V. Make it a different color or the two sights will run together when looking at them. Of course you only need to paint the rear face of the front sight bead. Good luck. If you don't like the look, you can clean off the paint with acetone.

 

[Ontario Hunter]

I once worked rotating shifts at an aluminum plant. Four of them for eight hour shifts: A, B, C, and D. I presume E shift = retired?