BRNO ZKK 602 Scope ring options?

[One Day...]

If you do a CZ 550 search on their website, BeeMaa, it gets you there

 

[BeeMaa]

If you do a CZ 550 search on their website, BeeMaa, it gets you there

Yes, and you will notice that they are not QD but screw lock detachable.

 

[One Day...]

Yes, and you will notice that they are not QD but screw lock detachable.

Check the option on the right: "with levers"

 

[BeeMaa]

Check the option on the right: "with levers"

Fair enough. But still have the levers on the right.

 

[Aaron N]

I prefer warne over talley for QD rings because the levers are much easier to time.

 

[Sideshow]

Do you guys know how much higher the 2blm are? Thanks

 

[Markinnz]

I had Warnes on my CZ 550 magnum,worked great,but some cz actions arent as trued as they should be leaving a lot of ajustment to the scope. Recknagell/ERA/EWA and MAK make detachable mounts that have adjustments in the mounts thus helping not having to adjust the scope too much.

 

[Sideshow]

Don’t need to worry about that as my Gun maker is going to check that when he does that other work that I’ve got it in for.
Thanks again guys for the tips

 

[Sideshow]

Just found the dimensions
1blm is 1.0795cm high
2blm is 1.3589cm high
That’s B so I’ve the option of lifting it a smidge if 1blm is to low.

 

[BeeMaa]

@Sideshow - Keep in mind that the levers on the Warne rings a a bit thin at the end where you put your thumb. The edges are also not rounded off. This did make it uncomfortable getting them off sometimes. Both the Alaska and Talley rings have a larger place for the pad of your thumb to snug/loosen them up with more rounded edges.

 

[Sideshow]

I’ve stuck a small sleeve of rubber on the ones that I have on my 7x57. Might do the same with these ones as well.

 

[Dirtdart]

If you do a CZ 550 search on their website, BeeMaa, it gets you there

View attachment 625960

I prefer these as they do catch, grab, or snag on things that I don't want them to but you do have to have the proper tool to remove them which is worth it IMHO.

 

[ZG47]

@Sideshow - Keep in mind that the levers on the Warne rings a a bit thin at the end where you put your thumb. The edges are also not rounded off. This did make it uncomfortable getting them off sometimes. Both the Alaska and Talley rings have a larger place for the pad of your thumb to snug/loosen them up with more rounded edges.

Wuss!

 

[BeeMaa]

Wuss!

Yep, that's me.

The gear needs to work for me, I shouldn't have to adapt to the gear. But you go ahead and do as you wish...tough guy.

 

[ZG47]

Yep, that's me.

The gear needs to work for me, I shouldn't have to adapt to the gear. But you go ahead and do as you wish...tough guy.

I am a carpenter, so … my hands are not as soft as some people’s. Easy option, which I once had to use, after leaving the scope attached for a bit longer than normal, is:
use a large dowel. I have an offcut from a round—hardwood—stair rail which is ideal for loosening up the levers. It is only about 8” long, if I recall correctly, and could be used for other items likely to be damaged by a hammer. Specialist outlets which market to joiners and woodworking hobbyists actually sell mallets with cylindrical heads, typically made of delrin, going by website images.
Your solutions make sense. Have a good weekend.