Ontario Hunter
AH legend
I'm not sure I see the necessity for 1/4 MOA when shooting deer at 200 yards. Sorry, but no one will ever convince me 55 gr is enough bullet for mule deer. Downside to hyperspeed bullets is the splatter factor at close range. Hyperspeed tiny bullets tend to go off track after impact. I feel an obligation to avoid wasting meat when I kill a deer. That means not blowing extra holes in it because it doesn't fall down instantly. That means ensuring a shot placed behind the shoulder doesn't exit out a rear ham. That means avoiding unnecessary bloodshot.I am fighting upstream on some of this, but truly believe bullet diameter and weight is too heavily relied upon by some, when faster TINY bullets can be stone cold killers. I have a .22/6mm (.224 TTH) that I would feel comfortable shooting any whitetail or mule deer with out to 200 yards or so with when loaded with .55 gr. TTSX. Same with .224 Weatherby. I had a .240 Weatherby that I was also quite comfortable with. These fast and light projectiles are poor choices where any brush may come into play. However, many very proficient hunters/shooters like to use them/similar chamberings and are deadly with them.
I am completely with you that I like two holes for every time I pull the trigger. I have hunted places so thick that if the deer ran 20 yards off the road/sendero that it made for a mess at times.
I think the .243 Win. Is not a great choice for deer, but the .243 Catbird, for example, is an awesome choice (with proper bullet). Again, it goes against the grain, but if using a .243 Win for deer, I would even go with lighter bullets and go for the added speed (without getting into a SD discussion).
I got a .30-.378 when I was 18 and killed a lot of animals with it. I still hunt quite often with a .340 Weatherby. My go to rifles are in .300 Jarrett, simply because they are truly 1/4 MOA rifles, and are devastating. I have hunted with a lot of other rifles as well, but would not feel under gunned with .224 TTH for hunting in many situations. This being stated, I would rather hunt with the TTH or even .220 Swift than the .243 Win. . My rambling insomnia induced point is don’t forget the speed component.
A few years back my buddy shot a nice mule deer buck the day before I arrived in Montana. He'd shot it with his 45-70 Marlin. I chuckled, "Sure you're using enough gun?" He chuckled back. "Why don't you help me skin it tonight." I was amazed. Big hole in behind front shoulder, big hole out behind opposite shoulder. NO BLOODSHOT. Almost none anyway. The definition of a clean kill. I'm not sure my 30-06 has ever done as clean a job. Needless to say that buck dropped on the spot.
Last edited: