mooze
AH senior member
- Joined
- Sep 19, 2018
- Messages
- 75
- Reaction score
- 89
I had the good fortune to by a rebuild Husquarna 146 from 1940 ( original cal 9,3-57) some ten years ago.
At the time Husquarna used FN 98 actions. It has served me well on too trips to Namibia and one tripp to south Afrika.
I use Barnes TSX 250gr.
I just read through this thread as I grew up with 9.3 guns ( which were the big boy's toys), so my 1st 9.3 was a custom 9.3x62 built on a DWM Berlin action. I was always turned off by the lack of available 9.3x64 brass although I wanted one badly so I began wondering about a 9.3 wildcat based on the 375 Ruger, which I then had realized 3 years ago. Reamer came from PTG and dies from Hornady. An initial test rifle built on a Browning Abolt 3 performed well so last year I had my local gunsmith built a CRF rifle on a FN Mauser/Browning. Forming brass is a one step thing. I have shot deer with very light monometals ( 155 gr flying at 3550 fps), the FN is currently loaded with 250 gr Nosler AB at 2860 fps ( slightly faster than the fastest 9.3x64 loads but there is also 12 gr more water -capacity in the case) and is awaiting this years moose or elk.
side note: the monometals ( MJG, Germany) have, from the 9.3x63 taken moose, black bear and deer without much ado, but for pure lung shots they sometime take a while to put the animal down, thus the switch back to lead.
So,to not hijack the thread: fast 9.3s are a wonderful alround gun!