Hummer
AH senior member
- Joined
- Mar 27, 2020
- Messages
- 69
- Reaction score
- 114
- Location
- Cradle of the Confederacy
- Media
- 6
- Articles
- 1
- Member of
- NRA Benefactor, Freemasons, Shrine, Eagle Scout,
- Hunted
- US
Had an extra reloading press so I figured WTH, figure out a portable press and this is what I came up with. It looks like it would wobble but does not. I made the legs and turned them in lathe and measured them with very long caliper and they are all within about .005" IIRC.
Cap screws hold them in place. The heads are exposed on the understand and sink into the carpet base and prevents the top side from moving. It is tall so I can do my loading standing up. I gave up on sitting down to reload many years ago. A Doc told me the longer you stand when you are young the longer you can stand when you are older and this is based on sound mechanical principle "When you legs go your rearend is not far behind." So I have been standing to load for last 40 years.
The vise is secured by bolts in tapped holes ground of smooth on bottom.
Note the indents in carpet the bolt heads make as indicated in fronts of the fired cases.
Note the base plate if laying on sections of rubber back commercial carpet and I can learn on it and it doesn't move on that steel table. Note I put carry handles on it so it is easier to move and placed them so the load would balance when I picked it up and if another helped carry it.
The top plate is drilled and tapped 7/8X14 so I can screw in extra dies.
Cap screws hold them in place. The heads are exposed on the understand and sink into the carpet base and prevents the top side from moving. It is tall so I can do my loading standing up. I gave up on sitting down to reload many years ago. A Doc told me the longer you stand when you are young the longer you can stand when you are older and this is based on sound mechanical principle "When you legs go your rearend is not far behind." So I have been standing to load for last 40 years.
The vise is secured by bolts in tapped holes ground of smooth on bottom.
Note the indents in carpet the bolt heads make as indicated in fronts of the fired cases.
Note the base plate if laying on sections of rubber back commercial carpet and I can learn on it and it doesn't move on that steel table. Note I put carry handles on it so it is easier to move and placed them so the load would balance when I picked it up and if another helped carry it.
The top plate is drilled and tapped 7/8X14 so I can screw in extra dies.
Last edited by a moderator: