Pay It Forward-Free

I somehow ended up with 2 copies of this book…this one is new. I’ll cover USPS flat rate box $ to lower 48 but ask you kick in the difference should your address be exotic. If you have less than 100 posts then submit your reciprocal PIF before I ship.
IMG_2559.jpeg
 
I would like it if it is still available, I will send postage to Alaska.
 
Reposting my still available bullets from before:

1 sealed box (100 ct.) 25 Cal 110 gr Hornady ELD-X

A mixed lot of .224 Cal bullets
- (39) Nosler Varmageddon 55gr
- (17) JLK 52 gr bullets
- (50-ish) unknown brand 50 gr Hollow Points
- open but new box (100) Sierra MatchKing 52 gr HPBT

Additional items I've found that someone might want:

- Some old handloads (loaded 1994-1997 according to labels) for 7mm Rem Mag. Message me for more details/load data if interested. About 40-50 total rounds. All look to be in fine condition. They've been stored in ammo cans inside a closet (not a garage, etc.) and I did fire a few though a BLR without any function issue.

- 19 rounds handloads from 2003 for 25-06. 117gr Sierra bullets. As above, look fine and same storage conditions. Message me if interested for additional load details.
+PLUS+ partial box (9 rounds) Winchester Ballistic Silvertip 115gr, 25-06.

- New in Box (opened but never used) 16 Gauge Lee Load All II. Thought I'd get into loaded shotshells for 16, but just never got around to it. Comes with 24 bushings according to the box.

- - - if someone in DFW area wants to meet me (or will drive to meet me locally), I've got several hundred 16 gauge hulls that I'd saved and will also give away, but I don't want to hassle with shipping these.
 
- - - if someone in DFW area wants to meet me (or will drive to meet me locally), I've got several hundred 16 gauge hulls that I'd saved and will also give away, but I don't want to hassle with shipping these.

If you can wait until sometime next week to link up, I’ll take the 16 ga hulls off of you…
 
Thank you @Hogpatrol for the sling! I’ll post some NIB rings that I have. Bought for my mannlicher CZ 550 in 9.3 x 62 but got the wrong size for my scope.
 

Attachments

  • IMG_9980.jpeg
    IMG_9980.jpeg
    2.6 MB · Views: 25
  • IMG_9981.jpeg
    IMG_9981.jpeg
    2.9 MB · Views: 25
If you can wait until sometime next week to link up, I’ll take the 16 ga hulls off of you…
Consider them yours. I'll send you a PM - no rush on my end for how long I hold them.
 
I’m not 100% certain if this is where I should post this or even if someone would want them…
I was at the range yesterday and there was a guy, whom I’ve never seen there before, who shot a bunch of .223 from an AR and then pulled out a CZ550 and fired a few rounds, swept up the brass and threw it in the brass bucket. After he left I checked it out and found it was .416 Rigby. I grabbed the brass. It’s only 12 pieces with Barnes headstamp.
If anyone in the lower 48 US wants them, they’re yours.

IMG_1151.jpeg
IMG_1150.jpeg
 
I am posting this Pachmayr Decelerator 1” butt pad that has been ground and polished out for my Ruger African .375 Ruger. It is new, as I decided to go with a thicker NECG pad for >LOP. I am surmising that the Ruger African stocks are all very close dimensionally and this pad may be a direct fit. This one measures 4.892 x 1.706 inches so if your African’s butt ( :sneaky: ) is the same or smaller size PM me and it’s yours.
IMG_2574.jpeg
 
much appreciated Papa72! I was actually just eyeing one for my recently purchased 35 Whelen Ruger African (pics below). I am in the middle of a move (actually forced out due to busted water pipe, and unable to get to my gun room) but a cleanout will begin soon and i will be putting more up for grabs in short order!

Ruger-M77-Hawkeye-35-Whelen_103099863_145843_68A62F21C651F119.jpeg
 

Forum statistics

Threads
61,099
Messages
1,335,187
Members
114,175
Latest member
TrudieoKranson
 

 

 

Latest profile posts

aquinn wrote on Raptor59's profile.
I'd like a bag of 100. I could actually pick it up since I'm in North Irving, but if you prefer, shipping it is fine.
Good day I'm Rainhold Neumbo form Namibia, I'm a professional taxidermist, anyone, can help me job I do mounting animal, full mounts, wall pedestal, shoulder mounts and many other, I'm based in Namibia I willing to travel where opportunities are, thank you, my WhatsApp number +264-814136480.
Email address neumbomakafa9@gmail.com
Just did a podcast, check it out if interested!

 
Top