Search results

I found a Lee mould for a cast six hundred grain bullet. I thought that would be the way to start. Still thinking it over

Impressive.

This gun is low cost for what it is but would I be better off to just spend more and get an off the shelf 416? I have been thinking that perhaps it's a better idea to start smaller. This big rifle comes with a set of dies brass and bullets and when you factor that all in the rifle is close to...

What would you think of mercury I'm the but stock? I was thinking two fourteen oz ones and then balance the rifle by adding weight in the forearm. My goal on paper was thirteen pounds or a bit more. I have a Schmidt and Bender 1-4 zenith series scope put it on or leave it off?

It weighs ten pounds. I was hoping it was heavier. No brake nobleford recoil reducers.

As you know Speer no longer makes 358 diameter grand slams. That is the particular rifle I am wan a different bullet for. I have a 358 sta Magnum that I got 3000 fps out of the 250 grain bullet. I never found a bullet all went through. I like that as well.

Finding premium bullets can be hard at times. I have never very much cared for partitions. Accubonds seem alright. I also liked the grand slams I have used. I like Remington lok cor ultra bonded only shot one animal with them so not a final judgment. I have bought a few boxes of a frames when I...

Good luck on your next day in the field

What does everyone think of these?

Please do let us know I would think that a 40 grain bullet in a 224 diameter gun would be quite a test for the bullet. A lot of people likely would not agree with me but my belief is deer rifles start at the 25-06. I live and hunt in open country that is really flat and you can see several miles...

I think I may try a few of the gcs 17 cal bullets and see what they do on animals bigger than ground squirrels. That should give an indication of how they will work with larger caliber rifles and big game but I can try them in the off season. I will have to email them to see if they ship to Canada.

I have used a vibratory tumbler for years. I am thinking about changing somewhat. I am thinking using it first then resizing and depriming and then the wet clean with the pins. That would clean the brass to keep the dies in new condition and then the brass would be clean inside and out...

Animals don't run to good if you break both front shoulders and the nose is in the dirt. The bone from the near side shoulder makes great secondary projectiles. Central nervous system hits are immediately deadly. Heart shots are relatively quick as well but not like a cNS shot though. Animals...

Great hunting

Interesting idea to google serial number. I have a vz24 that I built a custom on.

I will know that in ten days

Federal 215 s would be the primer of choice I would think

I was wondering about loads with trail boss and lead bullets. I contacted the seller and he will be back from a hunting trip in ten days so I will know more then. Looks to be a Boyd's classic stock on it. Built on a cz 550 Magnum. No brake

Do the mercury recoil reducer s do anything other that add weight?

How ugly is the recoil going to be? I have a 358 sta Magnum that I find easy to shoot. I also have a Browning bps 3 1/2 10 gauge. Shot it with no recoil pad and 2 1/4 oz loads. I knew that. After a recoil pad it is shootable. I found one that I am wondering about. I know I could load it down and...

Sounds like a good powder for the cartridge a slow burning rate.

Can you get any of the american powders? I should have data for accurate arms powder. As well.

Can you get imr hodgdon powder there

Hodgdon online load data has a lot of load data for the 6.5-06

I should have lots of loading info. I will look it up what powders to you have use? Also watch out with the 270 brass it could end up to long. Just measure it. Tell me what weights of bullets you are going to use.

So what would a hunt cost for a four animal hunt like that and could it be done in a week? How big of rifle would I bring? I would think a 22 250 would be big enough or what are the rules?

It might sound funny but one hunt I would like to try is what a fellow told me he did which was a hunt for a bunch of little deer antelope they were all the size of dogs.

Well I will go in the next five years or will not ever go. I built a 6.5 06 Ackley a 308 Norma mag and a 358 sta. Currently looking at a 460 g&a. All are Mauser actioned the 6.5 is built on a z24 action the 308 nm is built on an fun and the 358 is built on a witworth express action. The 460 is...

Thank you for letting me join your group. I have read numerous threads here over the years. I am from Canada. I have always wanted to hunt Africa and been building rifles to go one day. I have hunted around here my whole life started shooting skunks at the age of seven. Glad to be here and...