Seeking ideas and photos for buffalo skull mount on a pedestal

[Spearhead]

I like that one. That's pretty close to what I'm thinking too. Maybe with the @Spearhead suggestion about tilting it down to see more boss and less nasal cavity.......

@towserthemouser Reason I am going to build the one I sent is because I am adding a push magnet door to store bullets for reloading. Will have hunting photo hanging above it or close by. I'm considering lazy Susan type shelves to utilize the entire space (though small) and center pole that holds skull as the pivot point for shelves.

 

[JimmyJack54]

Skull/horn mount but not pedestal. Just an idea.

 

[Warren Knudsen]

I might do my next Buffalo like this!
View attachment 703528

I am planning to do the same.

 

[Spearhead]

@towserthemouser , found the downward tilt you like with the base you like, see below .

 

[PARA45]

The top picture of the floor pedestal is my work. I did that piece for a fellow AH’r.

Thanks Erik, and my apologies for not remembering who it belongs to.

 

[rafter3]

Take a look at these two. Unfortunately I cannot recall where I found these photos and can therefore give due credit neither to the taxidermist nor to the owner, but consider them food for thought.

First one: On a carved shield; just need to adjust the angle to suit your preferences.

View attachment 703797

Second one shows a shoulder mount on a cast-metal (aluminum?) pedestal. In your case, you would use a Euro mount adjusted to the appropriate angle.

View attachment 703798

Very possible that the original photos came from AH, so perhaps someone will recognize them and provide further information. Good luck with whatever you decide.

This shoulder mount one is at African Sky Hotel in Johannesburg I am hoping to do something like this also, any suggestions are appreciated.

 

[WAB]

My wife’s buffalo on our sideboard.

 

[towserthemouser]

@towserthemouser , found the downward tilt you like with the base you like, see below .

That is very close to what I was envisioning, thank you!

 

[gizmo]

Thanks Erik, and my apologies for not remembering who it belongs to.

No worries buddy.