Removing bolt jeweling

[PAUL_MAUSER]

Can jeweling be removed from a rifle bolt and claw extractor without causing any issues with reduced dimensions? I'm looking at and pondering a custom rifle however the one glaring thing I do not like about it is the jeweled bolt and claw extractor.

 

[roklok]

Most jeweling is very shallow, in fact it normally gets buffed out from normal use on contact areas of the bolt. It should be a simple matter to use fine sandpaper (600 or finer) to remove it. While technically any metal removal will affect the dimensions, it would be so slight to not make any practical difference in my opinion.

 

[JimP]

I would talk to a gunsmith instead of depending on a internet forum where you'll get a dozen different answers.

My opinion is that as long as it's on the bolt body and not the locking lugs you should be fine polishing it off. For the extractor, you can just replace it.

 

[Ontario Hunter]

I cannot see how buffing the jewelling from bolt body would affect anything. Don't touch the locking lugs or bolt guide I agree with above, simply replace the extractor and polish it with buffing wheel and compound. If the retainer for extractor was jeweled I would definitely replace it. Too thin to start with.