.330 Dakota Case Trimming

[Martin375]

Looking for some advice folks
Recently purchased a .330 Dakota and wanting to trim some brass
Any .330 users out there who can advise on what set up you are using for trimming brass
I'm in Scotland

Thanks,
Martin

 

[deewayne2003]

I just acquired a set of .330Dakota dies for a buddy.

The die in the middle is a form and trim die, this die sizes .404J to .330Dakota and it’s also a trim die.

Any brass protruding from the top of the die is removed by use of a flat file, then chamfer the mouth and your done.

 

[Martin375]

Thanks for that, l'll have a look at these dies