Recent content by 450 Dakota

47 bullets in the box. .458 550 gr North Fork SS bullets. $75 shipped to lower 48 states.

I’ll take them. PM sent.

Push

H4350 with 300 gr bullets works well.

Yes, you can. You can fire form regular brass to make cases if you want but they end up a little short in overall length but are useable.

I like the 375 Weatherby, getting ready to build one. Have 2, 375 H&H Ackley Imp and a 375 RUM. I have one H&H and it is my least favorite. In my experience few rifles shoot well with loads maxed out. You can back off the Weatherby and still have a great shooting round. If you don’t reload then...

RCBS Collet puller is a lot easier than the hammer type.

Is it long enough for a 375 H&H? I had a tang safety 338 but it’s been along time ago but I don’t remember it being long enough.

I had a 9.3-375 Ruger built on what was a 338 win mag model 70. No issues with feeding. Didn’t have to change any angles. The mag box had a spacer at he back of it that I removed for more room and shortened the bolt stop and ejector if I remember right.

300 PRC will be very tight unless you get a Wyatt’s extended magazine box. Which requires some machining on your receiver. If I’m going that route I’m getting a custom action. 7 PRC will fit.

I only use Hornady if it is the only option. Ex: 375 Ruger

Cummings Custom Refinishing

What reticle?

Is the brass Weatherby brass or another brand?

RCBS hand priming tool.