World's most popular community & resource for hunting in Africa since 2007
450 Dakota's latest activity
-
447 bullets in the box. .458 550 gr North Fork SS bullets. $75 shipped to lower 48 states.
-
-
4maybe more like 10 seconds! good snag Dakota!
-
4450 Dakota replied to the thread FS 416 bullets.I’ll take them. PM sent.
-
4450 Dakota replied to the thread Is this M70 a push feed or CRF, I can't see from the photos.Push
-
4450 Dakota replied to the thread 375 H&H A I.H4350 with 300 gr bullets works well.
-
4450 Dakota replied to the thread Your opinion on potential advantages of the .375 Weatherby?.Yes, you can. You can fire form regular brass to make cases if you want but they end up a little short in overall length but are useable.
-
4450 Dakota replied to the thread Your opinion on potential advantages of the .375 Weatherby?.I like the 375 Weatherby, getting ready to build one. Have 2, 375 H&H Ackley Imp and a 375 RUM. I have one H&H and it is my least...
-
4450 Dakota replied to the thread Bullet Removal.RCBS Collet puller is a lot easier than the hammer type.
-
4450 Dakota reacted to fourfive8's post in the thread .375H&H 25” Barrel cut to 23” - chronograph results with
Like.
6-3, 200. Similar experience/preference here. There is less muzzle jump/cheek thump and recoil with longer barrel. More inertia with... -
4450 Dakota reacted to Tex .416's post in the thread 416 rem mag now that r15 is not to be found what powder do you use? with Like.
RL15 has a slightly heavier minimum starting weight than Varget in most cartridges including the .416 Rem. Even if it did not, Varget...
-
4450 Dakota replied to the thread Should I use a Ruger action for custom build?.Is it long enough for a 375 H&H? I had a tang safety 338 but it’s been along time ago but I don’t remember it being long enough.
-
4450 Dakota replied to the thread Anyone built .375 or .416 Ruger on a Model 70.I had a 9.3-375 Ruger built on what was a 338 win mag model 70. No issues with feeding. Didn’t have to change any angles. The mag box...
-
4450 Dakota replied to the thread Re-chambering a rifle.300 PRC will be very tight unless you get a Wyatt’s extended magazine box. Which requires some machining on your receiver. If I’m going...
-
4450 Dakota replied to the thread Hornady Brass quality? What is your favorite brass for safari calibers?.I only use Hornady if it is the only option. Ex: 375 Ruger
