@tarbe If you truly saw the set up we had, you would know for sure that I'm 100% Appalachian American.
The drill press was separated from the base and turned 90 degrees then the base was clamped to a table.
The rifle is being held in place by two clamps, clamped to a 2x4 that's screwed to another 2x4 and held in a vice.
That grey thing around stock at the bottom clamp? That's a lure wrap to protect fishing lures...
Around the top I think was a piece of velcro strap I had laying around.
All that said, it got the job done and the hole was straight.
As I'm sure yours was as well, just without all the clamps and crap.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
